A SERVICE OF

logo

SECTION 3 DIMENSIONS
INTRODUCTION
This section has been designed to provide enough information to successfully layout a chassis in the body planning
process. All dimensions are inches unless otherwise noted. Optional equipment may not be depicted. Please contact
your local Peterbilt dealer if more dimensional information is desired.
ABBREVIATIONS
Throughout this section and in other sections as well, abbreviations are used to describe certain characteristics on your
vehicle. The chart below lists the abbreviated terms used.
TABLE 3-1. Abbreviations Used
CA
Cab to axle. Measured from the back of the cab to the centerline of the rear axle(s).
EOF
Frame rail overhang behind rear axle--measured from the centerline of tandems
FS
Front suspension height
RS
Rear suspension height
WB
Wheelbase
SOC
Side of cab
BOC
Back of cab