69
ENGLISH
69
Machine actions Causes Solutions
The machine grinds the
co ee beans but no co ee
comes out.
(See note)
There is no water. Fill the water tank and prime the circuit
(please refer to chapter “Manual rinse
cycle”).
The brew group is dirty. Clean the brew group (“Weekly clea-
ning of brew group” chapter).
This might occur when the machi-
ne is automatically adjusting the
dose.
Brew a few co ees as described in
chapter “Saeco Adapting System”.
The dispensing spout is dirty. Clean the dispensing spout.
Co ee is too weak.
(See note)
This might occur when the machi-
ne is automatically adjusting the
dose.
Brew a few co ees as described in
chapter “Saeco Adapting System”.
The co ee is too coarse. Change co ee blend or adjust the
grind as explained in chapter “Adju-
sting the ceramic co ee grinder”.
Co ee is brewed slowly.
(See note)
The co ee grind is too ne. Change co ee blend or adjust the
grind as explained in chapter “Adju-
sting the ceraminc co ee grinder”.
Circuits are clogged. Perform a descaling cycle.
The brew group is dirty. Clean the brew group (please refer to
chapter “Weekly cleaning of the brew
group”).
Co ee leaks out of the
dispensing spout.
The dispensing spout is clogged. Clean the dispensing spout and its
holes.
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case wait until
the machine performs a self-adjusting operation as described in chapter
“Saeco Adapting System”.
