10Electronic Program Guide (EPG) (for DTV Only)
English
61
En
4
Press / to select “ANALOG”, and then press
ENTER.
•A dialog box for confirmation appears.
5
Press / to select “OK”, and then press ENTER.
• The program is preset and the schedule table is
restored.
•A red square icon appears for the preset
program.
•A black icon appears for overlapped
presetttings.
6
Press DTV GUIDE to exit the Program Guide.
• Switch on the recording equipment at least 30
seconds before the start of the preset program;
otherwise recording will not be executed.
•Finish presetting operations two minutes before the
start of the program; otherwise presettings may fail.
•For priorities about overlapped presettings, see
“Priority rules for overlapped presettings” on page 63.
• Confirm that the video output terminals on the Media
Receiver have been connected to the signal input
terminals on the VCR to be used for recording.
• If you switch off the system using the POWER
button, the program presetting will become
ineffective. Be careful not to switch off the power.
Recording TV programs via a VCR
controller
If you connect an appropriate VCR controller to the
Media Receiver, you can preset digital TV programs for
recording with a connected VCR. See page 78.
1
Press DTV GUIDE.
• The EPG screen appears.
2
Press / and / to select a program to be
preset, and then press ENTER.
•A setup menu appears.
3
Press / to select “Program Rec”, and then
press ENTER.
•A dialog box for mode selection appears.
PDP5040HD-Eng (56-64) 7/24/03, 2:00 PM61
