11
12. Attach the ground wire on the Upright Wire (28)
to the indicated hole in the Base (48) with a #8 x
1/2" Ground Screw (27).
Press the indicated Grommet (6) into the Right
U
pright (36).
Raise the Right Upright (36) and the Left Upright
(not shown).
48
2
8
36
12
27
Ground
Wire
6
Hole
14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 20 and 21).
13. Raise the Frame (74) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (87) so that the large
barrel and the latch knob are oriented as shown.
Attach the upper end of the Storage Latch (87)
to the bracket on the Frame (74) with a 3/8" x 2"
Bolt (86) and a 3/8" Nut (47).
Attach the lower end of the Storage Latch (87) to
the Base (48) with a 3/8" x 2" Bolt (86) and a
3/8" Nut (47). Note: It may be necessary to
move the Frame (74) back and forth to align the
Storage Latch with the Base.
Lower the Frame (74) (see HOW TO LOWER
THE TREADMILL FOR USE on page 18).
87
48
47
Large
Barrel
74
47
13
86
86
Latch Knob
