20
POSITIVE 0° BEVEL STOP
See Figure 22.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
90° cuts.
TO CHECK
n Remove battery pack from saw.
WARNING:
Failure to remove battery pack from saw could
result in accidental starting, causing possible
serious personal injury.
n Place the saw in an upside down position on work-
bench.
n Using a carpenter’s square, check squareness of saw
blade to the base of the saw.
TO ADJUST
n Remove battery pack from saw.
n Loosen bevel adjustment knob.
n Loosen hex nut securing adjustment screw.
n Turn screw and adjust base until square with saw
blade.
n Tighten hex nut and bevel adjustment knob securely.
WARNING:
Attempting to make cuts without bevel adjustment
knob securely tightened can result in serious
injury.
OPERATION
Fig. 22
POSITIVE 0º
BEVEL STOP
BEVEL
ADJUSTMENT
KNOB
HEX NUT
ADJUSTMENT
SCREW
CARPENTER’S
SQUARE
BLADE
