8
Connecting Your Speakers
The Lucina AX-09 does not contain an amp or speakers.
In order to produce sound, you’ll need to connect the
rear panel OUTPUT jacks to an audio device such as an
ampli ed speaker system (subsequently referred to as
“speakers”), or use headphones.
Use audio cables (PCS series;
sold separately) to make
connections.
If you’re outputting in monaural, connect only the L/
MONO jack.
* To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn o
the power on all devices before making any connections.
Connecting Your Headphones
Connect headphones to the rear panel PHONES jack.
You can connect headphones that
have a stereo mini (1/8”) plug.
Turning the Power On
* Once the connections have been completed (p. 8), turn
on power to your various devices in the order speci ed.
By turning on devices in the wrong order, you risk
causing malfunction and/or damage to speakers and
other devices.
1. Minimize the volume of the Lucina AX-09 and your
speakers.
2. On the Lucina AX-09’s rear panel, turn the
[POWER] switch ON.
This unit is equipped with a protection
circuit. A brief interval (a few seconds)
after power up is required before the unit
will operate normally.
3. Turn on the power of your speakers.
4. Use the [VOLUME] knob to adjust the volume
appropriately.
While you play the keyboard
to produce sound, slowly turn
the [VOLUME] knob toward the
right, and adjust the volume
on the Lucina AX-09 and on
your speakers.
Turning the Power O
1. Minimize the volume of the Lucina AX-09 and your
speakers.
2. Turn o the power of your speakers.
3. Turn the Lucina AX-09’s [POWER] switch OFF.
