A SERVICE OF

logo

11
20 • Troubleshooting
* depending on model
Issues
Iron does not heat.
Yellow and red LED are
blinking alternately.
Thermostat control
light* or the yellow
LED* goes on and off.
Not enough steam.
Iron is emitting a brown
or white substance.
Solutions
Set the temperature
control to a higher
temperature.
Check that iron is plugged
in correctly.
Move iron or shake it
gently to reactivate.
Contact our Rowenta
Customer Relations
Helpline
When the Thermostat
control light* or the yellow
LED* gooes on and off the
iron is heating up. As soon
as the Thermostat control
light* goes off or the green
LED* lights up the set
temperature has been
reached.
Fill the water tank.
See section called
"Steam Ironing”.
Wait for the soleplate to
reach correct temperature.
See section "Water
Recommendations”.
Switch to spring water or
mix tap water with spring
water.
Ensure garment is rinsed
thoroughly to remove any
detergent deposits or
chemicals on new
garments.
Possible causes
The temperature control
is set too low.
Not properly plugged in.
Auto-off has engaged*.
The electronics has an
internal failure.
This is normal.
There is insufficient water
in the tank.
Iron is not set to a steam
setting.
The Anti-Drip function is
active *.
Water may need to be
changed due to hardness
or organic matter.
Garment has not been
rinsed sufficiently.
DZ9080 US 1103898398 10/05/06 11:00 Page 11