PowerLogic
TM
EM4800 Series 930-110-01-B.00
Installation 04/2011
© 201 Schneider Electric All Rights Reserved32
In Diagnostics mode, the right and left arrow buttons scroll the display from
meter 1 to 8, 1 to 12, or 1 to 24, depending on your configuration. When the
local IP address is shown on the LCD, use the right and left arrow buttons to
scroll through the following information:
• Remote host server IP address
• Time server IP address
• Default IP address
• Default NetMask
• Default gateway
• PPP user name
• Phone number
• AT command string
• Alternate phone number
• Unit serial number
• Firmware build number
• Ethernet port MAC address
• Firmware revision
• Potential transformer ratio
Remote Display For installation and operating instructions for the EM4800 Remote Display
(part number METSxEM48RD), refer to the "PowerLogic Remote Display Kit
for EM4800 Meters" technical document.
Recording the Meter Map The final step in the installation process is to complete the Installation
Record, and record the mapping of the meters to the wired points. A copy of
Figure 16, which is organised to resemble a breaker panel, is provided with
each PowerLogic EM4800 meter, and is to be completed and delivered to
your system administrator.
