OPERATION
Read this owner's manual and safety rules before operating your snow thrower.
Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.
Pivots the Upper Chute up or
down to control the angle and distance of dis charge.
Rotates the Lower and Upper Chutes to
control the direction of discharge.
Helps maintain the snow thrower in a
Used to lift or lower the snow thrower
to transport or op er at ing position.
holds the snow thrower in the up, transport position.
UPPER AND LOWER DISCHARGE CHUTE
direction and height of snow discharge.
Replaceable plate that absorbs
wear and impact from contact with ground.
Controls amount of clearance between
the scraper plate and the ground.
SPIRAL AUGER, R.H. & L.H.
impeller fan at the center of the housing.
HOW TO START YOUR SNOW THROWER
The tractor should be sitting with the engine run ning
at full throttle. Pull the at tach ment clutch switch out to
the en gaged position, starting the snow thrower before
starting the tractor in motion.
HOW TO STOP YOUR SNOW THROWER
• To stop the snow thrower, push in the attachment
clutch switch on the tractor. Refer to the Operation
section in your tractor owner's manual.
• Use the end of assembly checklist to verify that all
instructions have been properly completed.
• Make sure the skid shoes are adjusted to maintain
adequate ground clearance between the snow
thrower and the type of surface to be cleared. The
skid shoes are factory adjusted for clearing a smooth
surface. (Refer to the Service and Ad just ments
• Make sure the tractor engine has the correct oil for
winter operation. Refer to your tractor owner's man u al.
LIFT HANDLE
LIFT RELEASE TRIGGER
CRANK ROD
CHUTE TILT HANDLE
UPPER CHUTE
LOWER CHUTE
SPIRAL AUGERS, R.H. & L.H.
SKID SHOESCRAPER PLATE
LEVELING SHOE (Behind housing)
