ENGLISH
9
6. CONNECTING PREOUTs
• Use these jacks when adding additional power amplifiers.
• Connect the PREOUT jacks to the powered speakers or the power amplifiers connected to speakers respectively.
• When using only one surround back speaker, connect the SURROUND BACK LEFT jack to the power amplifier.
• If this is the case, you can connect the subwoofer without built-in amplifier to SURROUND BACK RIGHT terminals of the
power amplifier.(For details, refer to “When selecting the SUBWOOFER” on page 53.)
• To emphasize the deep bass sounds, connect a powered subwoofer.
Notes :
• After installing the speakers , first adjust the speaker settings according to your environment and speaker layout (For details,
refer to “SETTING THE SPEAKER SETUP” on page 49.)
• According to speaker settings, you cannot use either SURROUND BACK RIGHT jack or both of SURROUND BACK jacks.
7. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
8. CONNECTING DC TRIGGER OUT
• Connect a component to DC TRIGGER OUT jack that
allows DC 12 V to turn on or off when a specfic input
source is selected or not.
• For details, refer to the operating instructions of the
components to be connected.
• To link DC TRIGGER OUT with a specific input source,
refer to “When selecting the DC TRIGGER SETUP” on
page 61.
Notes :
• This output voltage (12 V d.c., 100 mA ) is for (status)
control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use
the stereo mini cord, not a mono mini cord.
