3
TECHNICAL DATA
Voltage rating 120 V, 60 Hz
Power 15 AMP
Light (Model SJ623E only) 12V 20W
No-load speed 2450 min¯'
Weight (SJ622E) 31.83 lbs/14.44 Kg
Weight (SJ623E with light) 34.04 lbs/15.44 Kg
Working width 18"/45.7 cm
Working height 10"/25.4 cm
Throwing speed 720 lbs/min
Throwing distance 30 ft/9 m
a. Read the operator’s manual carefully – Learn
your snow thrower’s applications and limitations as
well as the specic potential hazards related to this
machine. Do not use this machine for any purpose
other than the one for which it was designed.
Otherwise, it may cause mechanical defaults,
serious damage or personal injury.
b. Preliminary unit inspection – Thoroughly inspect
the unit before use. Make sure all the parts are
secure and installed correctly. If you notice any
abnormalities, do not use the machine until it has
been properly repaired. Always perform a test run
the rst time you use the snow thrower or after
replacing parts to ensure that the unit is functioning
properly.
c. Preliminary area inspection – Clear the area to be
plowed before each use. Remove all objects such
as rocks, broken glass, nails, wire, or string, which
can be thrown by or become entangled in the snow
thrower. Keep the area of operation clear of all
persons, particularly children and pets.
d. Excessive force – The snow thrower was designed
to respond at a certain rate for various snow
conditions for optimum safety and performance. Do
not force it; keep pressure constant.
e. Malfunctioning switch – Do not use the snow
thrower if the switch does not turn it on and off. Any
electrical appliance that cannot be controlled by the
switch is not safe to use and must be repaired.
f. Hitting an object – If the snow thrower accidentally
strikes an object, rst stop the snow thrower and
unplug unit; inspect for damage; repair or replace
any damaged part before restarting and operating
the snow thrower.
g. Discharge chute safety – Never direct the snow
discharge chute at the operator, at bystanders,
at vehicles or at windows. The throwing snow
and foreign objects accidentally picked up by the
snow thrower can cause serious damage and
personal injury. Do not use your hands to unclog the
discharge chute. Stop the motor before removing
debris.
h. Hand-held operating position – Operation of the
snow thrower in the hand-held position is unsafe.
i. Abnormal operation – If you notice the snow
thrower running in an unstable state or hear
abnormal sounds from the engine, stop the machine,
disconnect the power immediately, and contact your
original distributor.
j. Noise control – When using the snow thrower, you
must respect local laws and regulations regarding
noise control and environmental protection. To avoid
noise disturbance, you should carefully decide upon
an appropriate operation time and consider the
surrounding conditions.
k. When work is completed – Disconnect the snow
thrower from the power source when not in use,
when changing accessories, and before performing
any maintenance function.
l. Store safely – Store snow thrower indoors in a dry
area between uses. Keep in a locked area, where
children and unauthorized users cannot gain access.
Do not store the machine while it is still connected to
the power source. It may cause damage and injury.
m. Maintain for safety and longevity – Check for
misalignment or binding of moving parts, breakage
of parts, and any other conditions that may affect
the unit’s operation. If damaged, repair or replace
the damaged part before use. Use only those
replacement parts made for your model. When
replacing any parts, you must strictly observe
the instructions and procedures described in this
manual. Special care should be paid to any rubber
parts, since these parts may increase the engine
load and decrease its mechanical power if damaged.
Always check that all bolts, nuts, and knobs are
tight before using!
