5
GB
Main Power On/Off
switch
If you turn off the
Video TV by
using this button
and you do not
turn on it again
during 7 days, all
the settings will
be cleared.
Connecting the Aerial
Connecting an Indoor aerial (for KV-14FV1U only)
For a better reception we recommend you connect an external aerial. However, if your
local UHF signal is strong, you can connect the supplied loop aerial as follows:
1
Insert the loop aerial into the holder on top of the Video TV until it clicks.
2
Connect the aerial connector to the aerial socket
on the rear of the set.
3
After turning on the Video TV, adjust the aerial for optimum reception.
Connecting an Outdoor aerial
Connecting cables are not supplied.
Inserting Batteries into the Remote Control
Make sure to insert the supplied batteries using the correct polarities.
Always remember you dispose of used batteries in an environmental friendly way.
Overview of Video TV Buttons
Overview-Installation
Video
Input
jack
Audio
Input
jack
TIMER
REC
(recording)
on/off
button (see
page 13)
REC (Recording)
button (see page11)
Selecting Input source
Volume control buttons
Programme Up or Down
Buttons (Selects TV channels)
DIAL TIMER
(see page 12)
TIMER REC
(recording)
indicator (see
page 13)
REC
(recording)
button (see
page 11)
Standby
indicator
Headphone
jack
Tape transport buttons
(see page 10).
Press on the mark
on the
front of the Video TV to reveal
the front control panel.
Standby on/off
button
By using this
button to turn off
the Video TV
instead of the Main
Power on/off
button, settings
will not be cleared
unless the power is
interrupted or you
disconnect the AC
power cord. In that
case settings will
be cleared after 7
days.
