— 20 —
KV-20S90 / 21SE43C
V. SIZE ADJUSTMENT (VSIZ)
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select the VSIZ item with
1
and
4
.
4. Adjust value of VPOS with
1
and
4
for the best vertical center.
5. Press
MUTING
then
ENTER
to save into the memory.
V. CENTER ADJUSTMENT (VPOS)
1. Input a crosshatch signal.
2. Set to Service Adjustment Mode.
3. Select the VPOS item with
1
and
4
.
4. Adjust value of VPOS with
3
and
6
for the best vertical center.
5. Press
MUTING
then
ENTER
to save into the memory.
H. CENTER ADJUSTMENT (HPOS)
Perform this adjustment after performing H. Frequency.
1. Input a crosshatch signal.
2. Set to Service Adjustment Mode.
3. Select the HPOS item with
1
and
4
.
4. Adjust the value of HPOS with
3
and
6
for the best horizontal center.
5. Press
MUTING
then
ENTER
to save into the memory.
V. LINEARITY (VLIN), V. CORRECTION
1. Input a crosshatch signal.
2. V.Correction is automatically adjusted from the circuit and should
satisfy the conditions below.
V LINEARITY (VLIN)
V CORRECTION
SERVICE ADJUSTMENT MODE MEMORY
1. Change the value of the DCOL item to 1.
2. After completing all adjustments, press
0
then
ENTER
.
Read From Memory
Green
Red
ENTER
0
Mode
SERVICE READ
