Unpacking
16
Table of Contents
Unpacking ............................................................ 16
Package Contents ................................................ 17
Setting the DIP Switches ..................................... 17
Setting the SCSI ID (SAITe1300-S only) ........... 17
Setting the Loop ID (SAITe1300-F only) ........... 17
Installing the S-AIT Tape Drive Unit ................ 18
Connecting the Power Cable .............................. 18
Installing Device Drivers ..................................... 18
Connecting the SCSI Bus Cable
(SAITe1300-S only) ............................................. 19
Connecting the Optical Fiber Cable for Fibre
Channel (SAITe1300-F only) ............................. 20
Turning On the Unit ............................................ 20
What’s Next? ........................................................ 21
Unpacking
Note
You will need the box and packing materials if you wish
to move or transport the unit. Retain them for future use.
1
Remove the unit from the box as indicated below.
Remove the packing materials, such as plastic
covers and tapes.
2
Inspect the unit for shipping damage.
If there is damage, do not use the unit. Report the
damage immediately by contacting your dealer.
© 2003 Sony Corporation. All rights reserved.
Trademarks
• Sony, Advanced Intelligent Tape, and Super
Advanced Intelligent Tape are trademarks or
registered trademarks of Sony Corporation in this
country, other countries, or both.
• Other product names are trademarks or registered
trademarks of their respective owners in this country,
other countries, or both.
