35
Basic Operations
Terminating the UCP-8060
Before turning off the UCP-8060, perform the procedures
below to terminate the system.
1
Press the select L button (Menu) on the Main Screen.
The Menu display appears.
2
Turn the jog roller to select Shutdown.
3
Push the jog roller.
The Shutdown display appears, and the shutdown
process completes.
Note
Do not turn the UCP-8060 off before the Shutdown display
appears.
To cancel the shutdown process
Press the select L button (Back).
To perform soft reset
Press the select R button (Reboot).
To start the BIOS Utility
Press the select R button (Reboot) while holding the
function 1 button pressed until the function 1 button lights.
Then release the button.
To start UPDATE Utility
Press the select R button (Reboot) while holding the
function 2 button pressed until the function 2 button lights.
Then release the button.
Confirming of the Basic Information
Press the select L and R buttons while holding the function
1 button pressed for more than 3 seconds until the function
1 button lights. Then release the buttons.
The Basic Information of System [BIOS] Utility appears
on the screen to show the FPGA version, MAC address,
etc.
You can start the BIOS Utility from the Shutdown display.
For details, see “Terminating the UCP-8060” on page 35.
Retrieving the Main Screen
Press the select L button (Reboot).
Setting the Auto Start
If the Auto Start function has been set with the operation
software, the top page of the operation software
automatically appears after the Main Screen of the UCP-
8060 appears when the power is supplied to the unit.
Setting the Auto Start
To set the Auto Start function, follow the procedures
below.
1
Select the operation software to which the Auto Start
function is to be set on the Main Screen.
2
Press the select L button (Menu).
The Menu display appears.
3
Select Auto Start.
The Auto Start display appears.
4
Select ON.
5
Press the select R button (Save).
The Menu display appears.
Version : xxx Bulid date : xxx xx xxxx xx:xx:xx
FPGA Revosopm : xxx memorystick host controller : xxx
MAC Address : 08:00:46:xx:xx:xx
IP Address : 10.129.7.1
Netmask : 255.192.0.0
Gateway : 10.128.0.0
DNS : 0.0.0.0
MEMORY SIZE : xxMByte
Basic Information of System [BIOS] UTILITY
Reboot Memory Stick Format
ON
OFF
Auto Start
Exit Save
