STEP #2 - ASSEMBLE LEVERAGE ARMS:
1.Locate one of the LEVERAGE ARMS, slide it onto the corresponding shaft as show below, the side of the leverage
arms that has bearing and seal pre-installed will slide onto the corresponding shaft first.
2.After the one of LEVERAGE ARMS has been slid onto the corresponding shaft, install a full greased (20 MM ID
TAPPERED BEARING) with the small diameter of the bearing going first. Next install a (3MM thick, 17MM ID
WASHER) followed by a (TAB WASHER) , then a (BEARING NUT) as shown in Fig A. Note: the Tab washer will
have a tab protruding through the ID. This will need to align the slot in the shaft.
3.Using the provided nut driver tool tighten the bearing nut to the 7-9 Lbs-Ft torque. Check to make sure the bearing
are fully seated by wiggling the leverage arms, if there is excessive play in the arm you need to tighten the bearing nut
more.
4.Once the nut is tight, use a small flat screwdriver to bend one of the tabs on the tab washer into one of the four
notched in the bearing nut as shown in Fig B.
5. Repeat steps 1 thru 4 with the remaining LEVERAGE ARM as shown below.
Page 13
STEP #2 Completed
FIG:B
FIG:A
ALIGN 1 OF THE 6
TABS WITH THE
SLOT IN NUT. BEND
THE TAB INTO SLOT.
