13
ANTI-TIP BRACKET
INSTALLATION
WOOD FLOOR APPLICATIONS
Use the six #12 x 63,5 mm wood screws and
the six #12 flat washers provided. Drill pilot
holes 5 mm diameter maximum, and be sure
that the screws penetrate through the flooring
material and into the wall plate a minimum of
19 mm. Be sure that the screws hold tight.
Refer to illustration 1 below.
CONCRETE FLOOR APPLICATIONS
Use the two #10 x 95,25 mm concrete wedge
anchors, two #12 x 63,5 mm wood screws and
two #12 flat washers provided. Be sure that the
anchors and screws hold tight. Refer to
illustration 2 below.
IMPORTANT NOTE:
In some installations the
subflooring or finished floor may require
angling the wood screws used to fasten the
anti-tip bracket to the back wall. Refer to
illustrations 1 and 2.
INTEGRATED INSTALLATION INSTRUCTIONS
Make sure that there are no electrical
wires or plumbing in the area which the
screws could penetrate.
