First steps with your CD-GT1
hen we refer to a key or connector
hen we refer to a key or connector
or control on the we write it
or control on the we write it
hen we refer to an item shown on
the display we write it like this
e uses four
batteries not supplied e recom
mend the use of rechargeable i
batteries alkaline batteries may also
lways use batteries of the same
lways replace all batteries to
f you are not going to use the
for some time remove
lace the batteries following the
markings inside the battery
–
markings inside the battery
–
aximize battery life by using
the unit in the following tempera
ture range ° to ° ° to
lways dispose of used batteries
as recommended by your local
hen the battery level drops the unit
automatically shuts down and must be
the batteries have been replaced
ote that the battery indicator on the
display only provides a rough estimate
of remaining battery life and under
some circumstances there may not be
enough power in the batteries to power
the despite the battery
power indication on the display
nly use a adapter
not supplied sing another type of
adapter may damage your
lways make sure that the voltage
matches the voltage written on the
e has two power switches
switch to turn the power to the whole
and e ect unit f this section is o you
cannot use this jack or use any of the
guitarmicrelated menu systems e ect
the s controls and keys when
f the unit is powered using batteries
for more than minutes in stop mode
or with no disc loaded or opened the
player shuts down the part of
the display goes blank but you can
still use the guitar section
estart the player alone by using
PLAY
key or use the
PLAY
switch if both the and guitar sec
