Commands Listed in Alphabetical Order
BUS
Sets or returns the parameters for each bus. These parameters affect either the
Serial Trigger Setup or the Bus Display.
Conditions
This command requires a DPO4AUTO, DPO4EMBD, or DPO4COMP application
module.
Group
Bus
Syntax
BUS
BUS:B<1-4>:AUDio:BITDelay
Sets or returns the number of delay bits for the AUDIO bus.
NOTE. This command is applicable only for TDM audio bus type
(
BUS:B<x>AU Dio:TYPe TDM
)
Conditions
This command requires DPO4AUDIO application module.
Group
Bus
Syntax
BUS:B<1-4>:AUDio:BITDelay <NR1>
BUS:B<1-4>:AUDio:BITDelay?
Arguments
<NR1> specifies the number of delay bits.
Examples
BUS:B1:AUDIO:BITDELAY 2 sets the bit delay to 2.
BUS:B1:AUDIO:BITDELAY? might return :B US:B1:AUDIO:BIT DELAY 1
indicating that the number of delay bits is 1.
BUS:B<1-4>:AUDio:BITOrder
Sets or returns the bit order for the AUDIO bus.
Conditions
This command requires DPO4AUDIO application module.
MSO4000 and DPO4000 Series Programmer Manual 2-83
