7
PLAYING A CD
You can load and play music CDs and navigate a CD using the
buttons on the front panel.
First time use:
Lift the CD door to open the CD loading bay.•
Remove any transit packing that may be tted to protect •
the CD player in shipping.
Selecting CD operation:
Move the • FUNCTION selector on the top panel to select
the CD position.
The display on the front panel will light.
Loading a CD:
Lift the CD door to open the CD loading bay. •
Holding the disc by the edges, place the disc on the •
turntable in the centre of the CD loading bay with the
label uppermost. Press the centre of the disc into place
on the turntable with a click.
Gently close the CD door.•
The unit will read the disc and the display will show the total
number of tracks on the disc.
Removing a CD:
Ensure that the CD is stopped. •
Lift the CD door to open the CD loading bay.•
Holding the disc by the edges, lift the disc o the •
turntable and place it back in the case.
Gently close the CD door.•
Playing a CD:
Press the • PLAY/PAUSE button.
Pausing a CD:
Press the • PLAY/PAUSE button while the CD is playing.
The music will pause and the track display will ash.
Stopping CD play:
Press the • STOP button while the CD is playing.
The CD will stop.
Selecting tracks:
Press the • SKIP+ or SKIP- button briey to select the
next or previous track.
NOTE:- When pressing SKIP- while playing a track, the rst
press will replay the current track.
Fast search:
Press and • hold the SKIP+ or SKIP- button to fast search
forward or backward through a track.
The track will search at high speed.
Repeat play:
Press the • REPEAT button to cycle through the available
repeat modes - ‘Repeat 1’, ‘Repeat all’ or ‘Repeat o’.
The mode selected will be shown on the display.
Selecting ‘Repeat 1’ will continuously repeat the current track.
Selecting ‘Repeat all’ will continuously repeat the entire disc.
PROGRAM PLAY
You can load a disc and store a programmed selection of up to
20 tracks to play from the disc in your preferred sequence.
To set a program:
Load a disc and wait for it to read.•
Press the • PROG button.
The display will show 01 ashing (the position of this track in
the program).
Select the track number you want to program by pressing •
the SKIP+ or SKIP- button.
To save this track into the program sequence, press the •
PROG button.
The display will show 02 ashing, indicating that you are now
entering the second track in the program sequence.
Repeat the previous two steps until you have stored all •
the tracks in the program sequence.
Playing the program:
Press the • PLAY/PAUSE button to start the program
playing.
The program indicator will ash and the program will begin to
play.
Selecting tracks:
You can navigate through the tracks stored in the •
program by pressing the SKIP+ or SKIP- button.
