38
DSS
®
Satellite Receiver Set-up (continued)
VCR display
6
Select “CONTROL” using
PLAY
or
STOP
, and set to “On” or
“OFF” using
FF
or
REW
.
On: if your DSS
®
satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
→ Go to step 7.
OFF: if your DSS
®
satellite receiver is
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS
®
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
®
satellite
receiver.
→ Go to step 8.
7
Select “BRAND TYPE” using
STOP
, and enter a brand code
of your DSS
®
satellite receiver using
number buttons
. Refer
to the table on the next page.
Example: For a TOSHIBA DSS
®
satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press
PROG
. three times to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
®
satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step 6.
• The VCR Plus+ C system recording is not available on satellite channels.
• The DSS
®
satellite receiver control is not compatible with the cable box
control.
3
®
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
BRA
n
D TYPE no.99
SE
n
DING A TEST SIG
n
AL
TO YOUR CABLE BOX
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
BRA
n
D TYPE no. 36
W-608/TSB (ENG) 1/17/01, 11:05 AM38
