26
F-43
Adjust the brake if necessary. Insert the 2.0 hex wrench under the rear
brace as shown. The rear mechanism should spin freely without drag-
ging. If there is drag, loosen the brake adjusting screws slightly.
F-44
Rear Suspension:
Locate the left and right rear stub axle housings and (4) 5x11x4mm ball
bearings. Note that the stub axle housings are labeled “L” for left and
“R” for right. Press a ball bearing into the front and back of each stub
axle housing.
F-45
Locate the 38mm hinge pins, the 25.5mm hinge pins, (8) small E-clips,
and the rear camber links (38mm center-to-center distance). Also, find
the rear drive shaft assemblies from step D-9.
F-46
Snap a small E-clip into one groove of each of the four hinge pins.
F-42
Locate the graphite rear brace. Install the rear brace, as shown, with (6)
3x8mm buttonhead machine screws.
