B. REMOTE TEST
1. Connect one end of the
test cable to the
MASTER unit marked
TX .
2. Set the power switch to
ON and set the tester to
Auto scan. The TX LED will begin to scroll in
sequence (1,2,3,..., shield and repeat), to indicate the pins
being tested. Use a patch cord (included) if the test cable
terminates into a wall jack or patch panel.
3. At the remote location, connect the other end of the test
cable to the Remote terminator. The LED on the Remote
terminator will light (or not) in relation to the Master tester
unit to indicate status.
4. To test BNC, USB or other cable configurations, please
use the appropriate adapters and follow the above
procedure.
C. SENDING TONE TO IDENTIFY CABLES
Using Network cable tester s tone generator along with Net
Probe or any other tone probe, enables one to quickly isolate
and locate a hidden cable or a break (open) in the middle of a
5
