10
Rear Panel
1. DC Power Connector
The DC power input connector is located on the camera’s rear
panel, and is labeled DC5V 2.5A with a single jack socket to
supply power to the camera. Power will be generated when the
power supply is connected to a wall outlet.
2. Reset Button
Reset will be initiated when the reset button is pressed once, and
Power LED begins to flash. Factory Reset will be initiated when
the reset button is pressed continuously for three seconds or when
Power LED begins to light up. Release the reset button and the
Power LED will begin to flash, indicating the camera is changing
to factory reset. The IP address will also return to the default
setting as 192.168.0.20.
3. Network Cable Connector
The camera’s rear panel features an RJ-45 connector for
connections to 10Base-T Ethernet cabling or 100Base-TX Fast
Ethernet cabling (which should be Category 5 twisted-pair cable).
The port supports the N-Way protocol and “AutoMDIX” function,
allowing the camera to automatically detect or negotiate the
transmission speed of the network.
3 Network Cable Connector 1 DC Power Connector
2 Reset Button
