tSc TTP-244CE Manual

A SERVICE OF

next previous

32

Printer configuration will be restored to defaults as below after initialization.

Parameter

Default setting

Speed

127 mm/sec (5 ips) (203DPI)

76 mm/sec (3 ips) (300DPI)

Density

8

Label Width

4” (101.5 mm)

Label Height

4” (101.5 mm)

Sensor Type

Gap sensor

Gap Setting

0.12” (3.0 mm)

Print Direction

0

Reference Point

0,0 (upper left corner)

Offset

0

Tear Mode

On

Peel off Mode

Off

Cutter Mode

Off

Serial Port Settings

9600 bps, none parity, 8 data bits, 1 stop bit

Code Page

850

Country Code

001

Clear Flash Memory

No

IP Address

DHCP

4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor

Please follow the steps as below.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED turns green/amber after 5 green blinks. (Any

green/amber will do during the 5 blinks).

 The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5

blinks)  red/amber (5 blinks)  solid green

4.3.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Please follow the steps as below.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED turns red/amber after 5 green/amber blinks. (Any