The Speaker Terminals are located on the rear panel.
There are two SPEAKER terminals. Be sure to connect the
left channel (L), right channel (R), “+” (red) and “--” (black)
• Before connecting the speakers, make sure that the CDG-
6000RV is disconnected from the power source.
• Do not let the bare speaker wires touch each other or
another metal part of this unit. This could damage the
CDG-6000RV and/or the speakers.
Determining the proper way to connect the speaker
The speaker cable is a pair of insulated cables running side
by side. One cable is colored or shaped differently , perhaps
with a stripe, groove or ridges.
1. Connect one end of the striped (grooved, ridged, etc.)
cable to the “+” (red) terminal on the rear panel of the
2. Connect the other end of the striped (grooved, ridged,
etc.) cable to the “+” (red) terminal on the speaker.
3. Connect one end of the “plain” (NO stripes, grooves,
ridges, etc.) cable to the “--” (black) terminal on the rear
4. Connect the other end of the “plain” (NO stripes, grooves,
ridges, etc.) cable to the “--” (black) terminal on the
Preparing the Speaker Cable
You can either use an exposed speaker wire or Banana Plug
1. Remove approximately 3/8” (10mm) of insulation
2. Twist the exposed wires together to prevent short circuits
3. Loosen the knob on the speaker terminal
5. Tighten the knob until the wire is secure
