Plug It In...
3.prong groundlng
type wall receptacle
Recommended Groundlng Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Using
your
freezer
2. Turn control to Number 3. This setting will main-
Setting the Cold Control...
1. Insert a coin in the slot of the Cold Control to
tain zero zone temperatures under normal op-
turn it.
erating conditions.
Adjusting Cold Control.. .
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Cooling Freezer First.. .
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it cool overnight before adding large
amount of unfrozen food.
After the cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
Note: When freezer is first started the compressor
proper temperature.
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer lid is opened.
The outside of your freezer may feel warm. This
is normal. The freezer’s design and main function
is to remove heat from packages and air space
inside the freezer. This heat is transferred to the
room air so the walls of the freezer may be warm.
Exterior Signal light...
If the signal light is not glowing, immediately
check:
automatically warns of any unexpected power
failure.
0 for power interruption,
l
the power plug; it may be disconnected from
2.
, -Iht cover
g
the Outlet,
l
the warning light; it may be burned out.
To replace burned out slgnal Ilght:
1. Unplug power cord from outlet.
Carefully snap out light cover and assembly
with a screwdriver by inserting it under the
end of metal edge of the light. Be careful nOl
to chip finish on freezer.
Unplug burned out signal light and replace
with a new one. Signal light can be ordered
from your Whirlpool dealer.
Then, snap light assembly into place.
Plug cord into outlet.
Ke
The key eject lock can help reduce the hazard
of child entrapment..
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a replacement.
3
