CHANGING THE BIN DOOR PANEL
The storage bin door is designed to accept an
optional decorative wood panel of your choice.
The wood panel should be no more than ‘A inch
(6 mm) thick. Cut it to the same size as the
production metal panel. See Figure 1.
To change the panel:
1. Open the bin door.
2. Remove the two screws on top of the door
which hold the handle.
3. Remove the handle.
4. Slide the metal panel out.
5. Break off the ribs on the door insulation to
allow for the wood thickness. See Figure 2.
6. Slide the wood panel into the door frame.
7. Replace handle and screws.
13-3116”
WOOD
PANEL
DIMENSIONS
REMOVE ALL DOOR INSULATION
RIBS TO ACCEPT WOOD PANEL
THICKNESS
FIGURE 2
THERMOSTAT CALIBRATIONS
If ice maker is installed above two thousand feet of
altitude, the bin and evaporator thermostats must
be adjusted to a warmer setting. Disconnect
electricity, remove thermostat and follow the
directions for turning the altitude adjustment
screw as shown in the label on each thermostat.
SHIPBOARD OPERATION
When this ice cube maker is installed aboard a ship,
it will be necessary to purchase and install a water
deflector. This deflector hangs between the lower
edge of the evaporator and the cutter grid. It keeps
the water flowing over the evaporator from spilling
into the storage bin area. Order the necessary parts
from your local ice maker dealer.
2
