Install properly...
Remove sales labels...
3I[
-I I
a
-1
I
I
”
L
-47
1 Check the strength of the floor It should hold the
delght of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7 5 cm] arr space on top of freeze
for proper ventrlotrori
4 Allow at least an Inch (2 5 cm) be+,eerl trIc
freezer condenser, on the bock of the ilr!rt 3r:c
the wall
5 Allow ’ . inch [I 25 cnj on each side of +he ‘reeze:
for ease of Installatron
6 If the freezer IS to be agarnst a wall V::U rrrgiit
want to leave extra space on the hinge side so the
door can be opened wider
,’
The four bolts that held your freezer
ir
the
Shipis~rig
crate are designed to be the levellrng legs Screw
the legs far enough into the bolt holes, in each of
the four bottom corners, so the freezer stands
about 1 Inch (2 5 cm] off the floor
Level freezer...
so the door wtll stay
coen at any positior
Levelling Leg
Lower
Raise
Start adjustment with the door hinge side.
1 Slide freezer into place
2 Adjust front legs to level the freezer
To raise front, turn legs In direction shown
~ To lower front, turn legs In directron shown
3 Check with level
4 After freezer
IS
fullv loaded recheck iyrfh levei
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area with dtshwashing detergent solution (1
teaspoon detergent In 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it...
Ciean your freezer befor
using It See cleanrng
lnstrcctlons on page 6
Plug it in...
3-prong grounding
type wall receptacle
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrrcal supply is re-
quired It
IS
recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrrcal require-
ments and grounding Instruction sheet in your Irter-
ature package
4
