19
USING THE SELF-CLEANING CYCLE
SETTING THE CONTROLS
YOU SEE
OVEN ON light goes
on. DOOR
LOCKED/CLEAN-
ING light flashes
until you close door,
then is solid. HEAT-
ING light goes on
when oven starts
heating.
1. Set the oven control knob to CLEAN.
The door will lock itself within 6 seconds. If the
door has a problem locking, it will try to lock
itself for 1 minute. If the door fails to lock, the
Self-Cleaning cycle will cancel. An error code
will be displayed.
NOTE: Do not attempt to open the door while
in the locking mode.
2. Set the cleaning time (optional).
Press the “up” (s) or “down” (t) pad(s) to
select a clean time between 2 hours, 30
minutes and 4 hours, 30 minutes.
NOTE: The Self-Cleaning cycle will
automatically set a 3
1
⁄
2
hour cycle unless a
different time is selected.
3. During the last 30 minutes of the Self-Cleaning
cycle the oven will start to cool down.
Once the oven goes below the locked
temperature:
4. Turn the oven control knob to OFF.
5. After the oven is cool, wipe off any residue or
ash with a damp cloth or sponge.
If needed, touch up spots with a mild abrasive
cleanser or cleaning sponge.
YOU SEE
OVEN ON and DOOR
LOCKED/CLEANING
lights are on. HEATING
light goes off and COOL
appears in display.
YOU SEE
OVEN ON light flashes.
DOOR LOCKED/
CLEANING light goes
out when door unlocks.
PUSH AND TURN
TURN
YOU SEE
OVEN ON light
goes out and time
of day appears in
display.
