A SERVICE OF

logo

IES-1000 Hardware Installation Guide
Turning On Your IES-1000 5-1
Chapter 5
Turning
On Your IES-1000
This chapter discusses the fans and LEDs of the IES-1000 after you turn it on.
5.1 Introduction
Before turning on your IES-1000, make sure you:
Have attached a computer to the IES-1000 serial port as explained previously.
Can see the status LEDs on the front panel while you view the VT100 terminal emulator.
Push the power switch (located at the front of the IES-1000) to the ON or “|” position. The IES-1000 will
automatically run a self-test that takes approximately 20 seconds. The SYS LED will remain on if your IES-1000
has started normally.
If the SYS LED does not turn on then recheck your connections or refer to the Hardware
Troubleshooting chapter.
Make sure you can feel and/or hear the fans working — working fans emit a low buzz and blow air. The fans are
located on the IES-1000 as shown next. Refer to the Hardware Troubleshooting chapter to test the fans if they are
not working.
See the next section to interpret the operational status of your IES-1000.
Figure 5-1 Location of the IES-1000 Fans