Chapter 1 Getting to Know Your WAP3205 v2
WAP3205 v2 User’s Guide
14
1.8 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the WAP3205 v2 with the
connection cables.
5 Align the holes on the back of the WAP3205 v2 with the screws on the wall. Hang the WAP3205 v2
on the screws.
Figure 3 Wall Mounting Example
WPS Green On WPS is enabled.
Blinking The WAP3205 v2 is negotiating a WPS connection with a
wireless client.
Off WPS is disabled.
Table 1 Front Panel LEDs and WPS Button
LED COLOR STATUS DESCRIPTION
Table 2 Wall Mounting Information
Distance between holes 11 cm
M4 Screws Two
Screw anchors (optional) Two
