®
SeCtion 4 • Bilge & underwater gear
If the liquid level in the bilge is higher than
normal and the bilge pump empties the bilge
when you use the ON switch, the oat switch
is not operating properly. Have it checked
immediately. If the ON switch does not operate
the pump, DO NOT use the boat until the
problem is corrected.
Maintenance
Inspect the bilge pump intakes and keep them
free of dirt or material which may impede the
ow of water through the pump.
D. bilGe bloWer(s)
Run blowers when using the generator
or engine.
2. enGines anD sTern Drive
a. MainTenance anD service
Engine failure away from shore can be dangerous.
b. vibraTion anD causes
EXPLOSION/FIRE HAZARD – Run blower at least
four (4) minutes before starting engine or generator.
Check bilge and engine compartment for fumes.
! WARNING
Do not allow obstructions to interfere with bilge blower
or ventilation intake operation. Engine performance
may be adversely affected.
! WARNING