Filter
Top Products
SKU 66835 For technical questions, please call 1-800-444-3353. Page 5
IMPORTANT SAFETY
INFORMATION
Use caution when open-
ing the plastic case; risk
of electric shock.
Prevent body contact
with grounded surfaces such as
pipes, radiators, ranges, and re-
frigerator enclosures during instal-
lation.
WARNING! All connections MUST
be done with the Inverter’s Power
Switch off.
Connect all wires securely and
cover the connections with insulat-
ing rubber boots (not included).
Store metal objects away from the
inverter.
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
document including all text
under subheadings therein
before set up or use of this
product.
SET UP AND USE PRECAUTIONS
Set up only according to these in-1.
structions. Improper set up can cre-
ate hazards.
Wear ANSI-approved safety goggles 2.
and heavy-duty work gloves during
set up.
Keep area clean and well lit.3.
Do not set up when tired or when 4.
under the inuence of drugs or medi-
cation.
This product is not a toy. Do not al-5.
low children to play with or near this
item.
Use as intended only.6.
Inspect before every use; do not use 7.
if parts are loose or damaged.
Maintain product labels and name-8.
plates. These carry important safety
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Caution: This inverter must only be con-
nected to batteries with a nominal
output voltage of 12 volts. Lower
voltage will not operate the inverter
properly, and more voltage could
damage the inverter or the device
being powered. If more than one 12
volt battery is to be used, the batter-
ies must be connected in a parallel
circuit; batteries connected in a series
circuit will produce too much voltage.
Place the Power Inverter on a at 1.
surface. Make sure it has adequate
ventilation and is not in direct sun-
light. Locate the Inverter close
enough to the battery so that the
cables can easily reach between the
Inverter and the battery. Position the
Inverter so that the Outlets are easily
and safely accessible. Make sure the
Inverter is in its OFF position.
Using an 8AWG or larger ground-2.
ing wire (not included), connect the
Grounding Terminal to a ground-