Filter
Top Products
Chapter 3 Installing the Cisco Global Site Selector 4490
Installing Your Unit
3-10
Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-01
10. Tighten the captive screw (labeled 1 in Figure 3-6) on each side of the front
of the GSS 4490 to secure it to the rack.
Figure 3-6 Inserting the Inner Slide Rails
11.
Attach the power cord and the Ethernet cables to the GSS 4490.
Because the GSS 4490 does not contain cable retention brackets or cable
strain relief brackets, you must first bundle the external cables before you
route them. Use the remaining two cable straps to bundle the cables.
Note Leave sufficient slack in the cables to allow for sliding the GSS 4490 in
or out of the rack.
To remove the GSS 4490 from the rack, reverse these instructions.
1 Release tab
83201
1