Filter
Top Products
3-17
Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-01
Chapter 3 Installing the Cisco Global Site Selector 4490
Removing or Replacing a Cisco Global Site Selector 4490
Removing or Replacing a Cisco Global Site
Selector 4490
Warning
Before working on a system that has an On/Off switch, turn OFF the power and
unplug the power cord.
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Before removing or replacing a GSS 4490, you should logically remove the GSS
from the network before physically removing it.
To logically remove a GSS 4490 from the network, follow these steps:
1. Log on to the CLI (see the Cisco Global Site Selector Configuration Guide).
2. At the CLI prompt, enable privileged EXEC mode and then global
configuration mode on the device. For example:
localhost.localdomain> enable
3. Use the gss stop command to stop the GSS software running on the
GSS 4490. For example:
localhost.localdomain# gss stop
Power Green On Indicates that the GSS 4490 has power.
Flashing Indicates that the GSS 4490 is in standby mode.
Table 3-1 Front Panel LEDs (continued)
LED Color State Description