Filter
Top Products
12
• Over the top and match hook and loop straps
with each other.
•
Adjust fit with cam buckle.
Repeat for the remaining strap then attach the
other pontoon to its frame.
4. Inflate the pontoon completely.
Finish inflating the pontoons using both valves
in each pontoon as outlined in Step 3. Inflate to
approximately 2.5 psi. Inflate until firm but not
hard. Do not over inflate.
5. Assemble the seat base and
seat frame.
Locate the seat base and seat frame. You must
SIMULTANEOUSLY insert all four posts of the
seat base into the seat frame posts. A small
quantity of lubricant applied to the inside of the
seat frame receptacle posts with a paper towel
will greatly ease this step.
Place the seat frame on the ground with the open
ends of the four small posts facing up. Now place
(do not yet insert) the four small posts of the seat
platform over the seat frame posts as shown.
With the seat platform posts leaning in, slightly
press in all four of the seat frame receptacle
posts, then put your full weight evenly across
both seat platform rails and press them all the
way down.
If you can’t press the seat platform into the seat
frame you can turn the assembly upside down
(so that the fabric is on the ground) and stand
on the seat rails. You can also use a rubber
mallet.
6. Attach the seat frame to the
pontoon frames.
Locate the seat base and find the curved legs.
With the curved legs to the front, insert the seat
platform rails onto the pontoon frame posts.
(The front of the pontoon frames are the ends
labeled “L” and “R”).
Now insert four of the short clevis frame pins
from the top down into the holes where the four
seat platform rails slide onto the pontoon frame
posts. Each wire security retainer must go over
the seat frame rail and then over the clevis pin
as shown.
You MUST lock the security retainers on
all four clevis pins to insure that the frame
stays together.
7. Insert the foot pegs.
Locate the front of the pontoon frames, (the end
Pontoon
Frame
Cam
Buckle
Right
Pontoon
Completed seat base
and seat frame