Filter
Top Products
CLEAR BLUE HAWAI I
2123 Eluwene St. Honolulu, HI 96819
TOLL FREE : 1-877-777-6708
INTERNATIONAL : 1-707-202-8346 FAX : 1-707-317-5367
www.clearbluehawaii.com
Molokai Kayak Instructions
It is best to find an open, clean area in which to assemble the Molokai Kayak
Place the gray base skin flat on the floor and assemble the
base rod (x1) and side rods (x2).
The rods are connected on the inside by elastic cords
[ Assembly ]
1.
Locate the side rod flaps and insert one rod into each side,
as far as they will go.
The side rods are the two longest pieces with no black
plastic clips. Both rods are identical therefore it does not
matter which one goes in either side. It is best not to insert
them at an angle, lie the bottom skin flat on the floor and
move the side rod in parallel to the ground.
2.
Insert each corner rod into either end of the base rod
The base rod will be at an angle in the center, this becomes
straight as the cross ribs are inserted later.
The plastic latch at the top of the corner rods should clip
securely into the bolt screws at each end of the bottom skin.
3.
Place the joined base rod and corner rods into the center of
the bottom skin
4.