Filter
Top Products
No display on LCD when
radio is turned
On
Batteries are exhausted
Batteries not installed
properly
Recharge or replace batteries
Remove batteries and reinstall
according to polarity markings
NiMH batteries run
down quickly
Batteries are at the
end of their life
Replace with new batteries
Will transmit at
1 watt, but not
at 5 watts
Batteries are low
Selected channel is
limited to 1 watt
Recharge or replace batteries
Switch to another channel
Will not transmit Selected channel is
limited to receive only
Switch to
another channel
No sound from speaker Volume level is too low or
squelch level is too deep
Re-adjust volume
and squelch
No response to
button press
Key lock is On Press Backlight/
Key Lock
button
No answer to calls Out of range of
other station
Signal is blocked
by terrain
Switch to 5 watts or
move closer
Move until you have a “line-of-
sight” to the other station
Maintenance and
Troubleshooting
Nothing comes close to a Cobra
®
43
Advanced Operation
42
English
To enter memory location scan:
1.
From Standby mode, press the Memory button.
2. Press the Scan button.
The radio will immediately begin to scan the channels you
programmed into the memory. The
Scan and Memory icons
will show on the LCD.
To exit memory location scan:
1.
From Memory Location Scan mode, press the Scan
button. This will return the radio to Memory mode on
the last scanned memory location.
2. Press the Memory button to return to Standby mode on
the last channel shown before entering memory scan.
During memory location scan (while receiving
an incoming transmission), you can choose
from the following:
a. Press the Talk button to remain on that memory
location and end scanning. This will return the radio
to
Standby mode.
b. Press the Channel Up or Channel Down button to
resume scanning memory locations.
If you do not press any buttons within ten seconds, your
radio will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a.
Press the Talk button to communicate on the last
memory location scanned and return to Standby mode.
b. Press the Channel Up or Channel Down button to
change scan direction.
Memory Button
Scan Button
Memory Scan Mode
Operating Your Radio Operating Your Radio
a
Talk or Channel Up/Down
b
Problem Possible Cause(s) Solution(s)
Maintenance
•
Very little maintenance is required to keep your CobraMarine
™
VHF radio
in good operating condition.
■
Keep the radio and charger clean by wiping with a soft cloth and mild
detergent. Do not use solvents or harsh or abrasive cleaners, which could
damage the case or scratch the LCD screen.
■
If the radio is exposed to salt water, wipe with a soft, moist cloth at least
once a day to prevent build-up of salt deposits, which could interfere with
button operation.
■
If the radio will be stored for a long period, such as over the winter,
remove the batteries from the battery tray and store them in a separate
package. This is especially so if you are using alkaline batteries.
Troubleshooting
•
400-BR-F 6/23/04 2:12 PM Page 42