Filter
Top Products
-
7
-
Deutsch Español Français Italiano
Nederlands
SvenskaEnglish
Installing the main unit
Installing the main unit
Insert the mounting sleeve into the opening in the
vehicle dashboard or console box.
1
Use a screwdriver or the like to bend the tabs in
the mounting sleeve to secure the mounting
sleeve.
2
30˚ or less
Level (reference)
Front
-
Installation angle
-
Bend the mounting
tabs.
Dashboard or console box
Attach the side brackets to the main unit using
flathead screws.
3
Install the bezel on the main unit.
7
- Main unit installation example (If installing the main unit using the mounting sleeve) -
Side brackets
Flat head
screws
(Red:M5 x 8)
x 2
To maintain proper function, the unit must be
mounted at less than 30 degrees. If the angle is in
excess of 30 degrees, CD skipping or ejection may
occur.
Tip
•
Carefully bind any excess length of cord that is
connected to the main unit and secure it to an
area of empty space in the vehicle so that it does
not move around or get caught in the main unit or
vehicle-side equipment. If the cords are not
handled correctly, operating problems or short-
circuits may occur, and this may result in the
danger of fire or other accidents.
•
Connect all cables before installing the main
unit.
Tip
Main unit
1
Mounting sleeve
3
Bezel
5
Mounting sleeve
3
Bushing
9
Metal of vehicle
Stud bolt
8
Fasten the rear of the main unit.
6
Mount the stud bolt to the main unit.
4
Insert the main unit into the mounting sleeve until
it locks in place.
5
Dashboard or console box
Be sure to use the supplied accessory mounting
screws (Red:M5 x 8) as the mounting screws. If
any other screws are used, they may damage the
inside of the unit.
Tip
7
4
•
Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
•
This installation method is only one example.
When installing the main unit to the vehicle, be
sure to as the place of purchase for information
on what installation method to use.
Tip