Filter
Top Products
www.elationlighting.com/
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!"2////////////////////////#$%$#!&'(!)*+,!-./0.1!234
FuncMode - SetSlave
Define the fixture as slave.
1． Access the main menu by pressing MODE/ESC.
2． Press the UP/DOWN buttons until “FuncMode” is displayed and press ENTER.
3． Press the UP/DOWN buttons until “SetSlave” is displayed and press ENTER.
4． Press the UP/DOWN buttons to select desired value (Slave 1, Slave 2, Slave 3).
5． Press ENTER to confirm selection.
FuncMode - AutoProg
Define the fixture mode (= Master, = Alone) for running Auto Programs. Select the desired
internal programs under “Sel Prog”, set the number of steps under “Edit Prog”, and edit
the individual scenes under “Edit Scen”.
1． Access the main menu by pressing MODE/ESC.
2． Press the UP/DOWN buttons until “FuncMode” is displayed and press ENTER.
3． Press the UP/DOWN buttons until “AutoProg” is displayed and press ENTER.
4． Press the UP/DOWN buttons to select desired value (=Master, =Alone).
5． Press ENTER to confirm selection.
Info - TimeInfo - Cur Time
Display the run time of the fixture from the last power ON.
The counter is reset after turning the device off.
1． Access the main menu by pressing MODE/ESC.
2． Press the UP/DOWN buttons until “Info 2” is displayed and press ENTER.
3． Press the UP/DOWN buttons until “TimeInfo” is displayed and press ENTER.
4． Press the UP/DOWN buttons until “Cur Time” is displayed and press ENTER and
the display will show “XXXh” (hours).
5． Press MODE/ESC to return to previous menu or display will automatically exit.