Filter
Top Products
Quick Installation Guide
00825-0100-4716, Rev DA
October 2009
Rosemount 3095 MultiVariable
18
PRODUCT CERTIFICATIONS
Rosemount 3095 with HART
Approved Manufacturing Locations
Rosemount Inc. — Chanhassen, Minnesota USA
Emerson Process Management GmbH & Co. — Wessling, Germany
Emerson Process Management Asia Pacific Private Limited — Singapore
Beijing Rosemount Far East Instrument Co., Limited – Beijing, China
European Directive Information
The EC declaration of conformity for all applicable European directives for this product can
be found on the Rosemount website at www.rosemount.com. A hard copy may be obtained
by contacting our local sales office.
ATEX Directive (94/9/EC)
Emerson Process Management complies with the ATEX Directive.
European Pressure Equipment Directive (PED) (97/23/EC)
3095F_2/3,4/D and 3095M_2/3,4/D Flow Transmitters
— QS Certificate of Assessment - EC No. PED-H-100 Module H Conformity
Assessment
All other 3095_ Transmitters/Level Controller
— Sound Engineering Practice
Transmitter Attachments: Process Flange - Manifold
— Sound Engineering Practice
Electro Magnetic Compatibility (EMC) (2004/108/EC)
3095 Flow Transmitters — EN 61326-1:1997 – A1, A2, and A3
Ordinary Location Certification for Factory Mutual
As standard, the transmitter has been examined and tested to determine that the design
meets basic electrical, mechanical, and fire protection requirements by FM, a nationally
recognized testing laboratory (NRTL) as accredited by the Federal Occupational Safety and
Health Administration (OSHA).
Rosemount 3095 HART Hazardous Locations Certifications
North American Certifications
FM Approvals
A Explosion Proof for Class I, Division 1, Groups B, C, and D. Dust-Ignition Proof for Class
II/Class III, Division 1, Groups E, F, and G. Enclosure Type 4X. Factory Sealed. Provides
nonincendive RTD connections for Class I, Division 2, Groups A, B, C, and D.
J Intrinsically Safe for use in Class I, II and III, Division 1, Groups A, B, C, D, E, F, and G
hazardous outdoor locations. Non-incendive for Class I, Division 2, Groups A, B, C, and
D. Temperature Code T4. Factory Sealed.
For input parameters and installation see control drawing 03095-1020.