Filter
Top Products
Fitting instructions for the 2Kw xenon lamp
Referring to the diagram overleaf:
1) Unfasten the ten latches (A) on the front and rear of the searchlight;
2) Remove the front bezel (B) and rear bezel (C) assemblies;
3) Unscrew the two M6 hexagon screws (D) from the front lampholder mounting block (E) and
remove the front lampholder assembly from the mounting bracket;
4) Loosen the knurled screw on the front (F)and rear (G) lampholder assembles;
5) The lamp can now be inserted, make sure that the negative (cathode) end of the lamp is
towards the rear of the searchlight;
6) Tighten the knurled screw (G) on the rear lampholder assembly to hold the lamp in
position;
7) Fasten the front lampholder mounting block back in position, it will be necessary to pull the
front socket against its spring to fit over the lamp. When in place tighten the front knurled
screw (F);
8) Fasten the front and rear lampholder leads as wiring diagram, ensuring the connections
are secure;
9) The front bezel and rear bezel can now be replaced.
10) Removal is the reverse of the above.