Filter
Top Products
3. PLOTTER OPERATION
3-34
3.8.3 Erasing waypoints
Erasing a waypoint with the cursor
1. Press the cursor pad to turn on the cursor.
2. Operate the cursor pad to place the cursor on the waypoint you want to erase.
A flashing diamond mark appears over the waypoint when the waypoint is
correctly selected.
3. Press the [CLEAR] key. You are asked if you are sure to erase the waypoint.
4. Push the [ENTER] knob. The waypoint is erased from both the plotter screen
(if it is currently displayed) and the waypoint list.
Note: You may also erase a waypoint while the waypoint entering mode
(“WAYPOINT BY CURSOR”) is active as follows:
a) Place the cursor on the waypoint to erase.
b) Press the EDIT/MOVE soft key.
c) Press the ERASE WPT soft key followed by the [ENTER] knob.
d) Press the RETURN soft key to finish.
Erasing a waypoint from the waypoint list
1. Press the [MENU] key to open the menu.
2. Press the WAYPOINTS/ROUTES and WAYPOINTS soft keys.
3. Press the LOCAL LIST or ALPHANUMERIC LIST soft key.
4. Use the cursor pad to select the waypoint you want to erase.
5. Press the ERASE WPT soft key. You are asked if you are sure to erase the
waypoint.
6. Push the [ENTER] knob. The waypoint is erased from both the waypoint list
and the plotter screen (if it is currently displayed).
7. Press the [MENU] key to close the menu.