Filter
Top Products
21
3. SETTING UP THE EQUIPMENT
3.1 Setting up with the Installation Wizard
After you have installed the equipment, set up the equipment with the installation wizard.
The wizard allows you to easily set up the NavNet network (choose source of radar,
sounder and auxiliary), GPS, ports, etc.
1. Press the POWER/BRILL key to turn on the power, and the following screen appears.
NEXT
EXIT
ENTER
INSTALL
WIZARD
LANGUAGE
▲
~ ENGLISH
{ FRANCAIS
{ DEUTSH
{ ITALIANO
{ PORUTGES
{ ESPANOL
{ DANSK
{ SVENSKA
{ NORSK
▼
Installation wizard, language selection window
2. Rotate the ENTER knob to choose the appropriate language and then push the ENTER
soft key.
3. A dialog box asks you if you want to start the simulation mode, which provides
simulated operation of the equipment.
4. Press the CLEAR key to skip the simulation mode. Then, the SELECT MODE window
appears.
SELECT MODE
▲
~ INST. WIZARD
{ INST. MODE
{ SIMPLE CHECK MODE
{ NORMAL MODE
▼
CHANGE OR CONFIRM THE ITEMS SHOWN
ABOVE. THEN PUSH [NEXT] WHEN DONE.
5. Confirm that INST. WIZARD is selected, and then push the ENTER soft key. A
diagnostic test is conducted and then the chart disclaimer message appears.
6. You are then asked “LOAD SETTING DATA FROM CARD?”. This allows you to use the
set up this NavNet unit with the settings of another NavNet unit, thereby shortening the
time required to set up the equipment. To use the settings of another NavNet unit, insert
the appropriate SD card in the slot and push the ENTER knob. If not, hit the CLEAR key.
If you loaded settings, the message “LOADING COMPLETED. REMOVE THE CARD
AND PRESS ANY KEY TO RESTART” appears if loading was successful. Remove the
card and press any key to restart the equipment; installation is completed. To set up
manually, go to step 7.