Furuno 1734C Fish Finder User Manual


 
31
32. Choose item and press the EDIT soft key. Choose appropriate setting and then press
the ENTER soft key. Refer to the table and sentence description on the next page for
details.
33. Press the NEXT key, and the DATA3 (PC/NMEA/EXT BUZZ) port setup menu appears.
Set up this port similar to how you set up the DATA1 port.
NMEA
OUTPUT FORMAT
NMEA Ver 2.0
BAUD RATE
4800bps
BIT LENGTH
8 bits
STOP BIT
1 bit
PARITY
NONE
(Control: Xon/Xoff)
Installation wizard, DATA3 (PC/NMEA/EXT BUZZ) port setup menu
Description of items in “port” menus
Item Descri
p
tion Settin
g
s Default Settin
g
Output Format
(DATA1 port),
NMEA Output
Format (DATA3
port)
Selects NMEA output version for
the equipment connected.
NMEA0183 Ver. 1.5,
NMEA0183 Ver. 2.0
NMEA0183 Ver.
2.0
Baud Rate
Choose baud rate of equipment
connected.
DATA1 port:
AUTO*
1
, 4800 and
38400*
2
(bps)
DATA3 port: 4800,
9600, 19200 (bps)
4800
Lat/Lon Format
Selects latitude/longitude format to
output.
DD°MM.MM’,
DD°MM.MMM’,
DD°MM.MMMM’
DD°MM.MMM’
XTE Format
Selects number of XTE digits to
output.
X. XX,
X. XXX
X. XX
Output
Destination
Selects whether to output route
(data sentence RTE) and waypoint
data (data sentence WPL) when
destination is set.
Yes, No No
Bit Length
Choose bit length of equipment
connected.
7, 8 (bits) 7 bits
Stop Bit
Choose stop bit of equipment
connected.
1, 2 (bits) 1 bit
Parity
Choose parity of equipment
connected.
Even, Odd, None None
PORT MNITR
(soft key)
Use this key to view which sentences are being output. See the example on
then next page
*
1
Auto detection of baud rate of connected equipment. For use only with device having
“AUTO” feature.
*
2
Choose 38400 bps when connecting an AIS Interface or AIS Transponder to the DATA1
port.