Filter
Top Products
1-5
6. Loosen four screws and remove the cable clamping plate and the gasket.
Antenna unit, inside view
7. Set the signal cable through the hole at the bottom of the radome base.
8. Fasten the signal cable with the cable clamping plate and gasket. Connect the shield and vinyl
wire to the ground by one of the screws of the cable clamping plate.
A
ntenna unit: RSB-0071-057
XN10A-RSB-0070/0073-064
XN12A-RSB-0070/0073-059
A
ntenna unit: RSB-0071-057A
XN10A-RSB-0070/0073-064A
XN12A-RSB-0070/0073-059A
Shield cover
Shield cover
Screws
7 pcs.
Screws
7 pcs.
Screws
6 pcs.
Shield cover
Screws
4 pcs.
Gasket
Cable clamping plate
Shield cover
Shield cover
Screws
7 pcs.
Screws
7 pcs.
Screws
6 pcs.
Screws
4 pcs.
Gasket
Cable clamping plate