Filter
Top Products
4. MENU OPERATION
4-8
When towing the net
When a boat is in tow of the fishing gear, its stern is “dragged” by the net. This causes the
boat to stray from its intended course. To keep the boat on course, you need to adjust the
trim manually, which can be bothersome. If you do not want to be bothered with trim
adjustments, you can enable the automatic towing function to have the trim automatically
adjusted. This feature is very valuable for trawlers and purse seiners.
1. Rotate the course control knob to select “AUTO NET TOWING” from the PARAMETER
SETUP menu.
2. Press the course control knob to show the net towing options window.
ON
OFF
Auto net towing options window
3. Rotate the course control knob to select ON or OFF as appropriate.
4. Press the course control knob to finish.
If the AUTO NET TOWING setting is done on the AUTO mode menu, press the [STBY] key
to go into STBY mode and then press the [STBY] key to return to the AUTO mode to
activate this function.
Note that you must keep the boat on a straight course before the AUTO mode is selected.
NAV MODE
See the paragraph 3. 3. 2. "Selecting sailing method of NAV mode".
Selecting the navigator connected
When two navigators are connected, you can select one appropriately.
1. Rotate the course control knob to select "NAV SRC" from the PARAMETER SETUP
menu.
2. Press the course control knob to show the nav mode data source window.
PORT 2
BOTH
PORT 1
Nav mode data source window (ex. default setting)
3. Rotate the course control knob to select PORT 1*, PORT 2* or BOTH as appropriate.
For “BOTH”, Navpilot-511/520/611 uses the port input the higher priority data (See the
installation manual). If same priority data are input to the port 1 and port 2, the port 1 is
used.
4. Press the course control knob to finish.
*: Default set name. These can be changed on the installation menu.