Filter
Top Products
30 VHF 300 Series Owner’s Manual
Advanced Operation
Selecting NMEA 0183 or NMEA 2000
This setting determines whether you are connected to a NMEA 0183 network or a NMEA
2000 network. The radio can only communicate over one network type at a time.
To congure a VHF 300 or a VHF 300i:
1. Press the MENU key.
2. Select COMMUNICATIONS > PROTOCOL.
3. Select NMEA2000 or NMEA0183.
To congure a VHF 300 AIS or a VHF 300i AIS:
1. Press the MENU key.
2. Select COMMUNICATIONS > PROTOCOL.
3. Select NMEA2000 or NMEA0183.
4. If you selected NMEA0183, select one of the following options:
If AIS is disabled, select NMEA STANDARD or NMEA HIGH SPD.
If AIS is enabled, you can only select NMEA HIGH SPD.
MMSI (Vessel) Filtering over a NMEA Network
Your radio can send call-related data over NMEA 0183 or NMEA 2000 when it receives
distress calls, acknowledgements to position request calls, and other position-send calls. You
can lter the MMSI numbers (vessels) for which your radio sends this data in three ways:
any MMSI number (all vessels), no MMSI numbers (no vessels), or select MMSI numbers
(vessels selected from your directory).
When you congure the radio to send data for select vessels, and you receive an
acknowledgement to a position request call, or other position-send call from an MMSI
number not in your directory, your radio does not send NMEA data for that call. Distress
call information will still be sent. For more information about NMEA output from your
radio, see page 49.
Conguring MMSI Filtering for Select Vessels
1. Press the MENU key.
2. Select COMMUNICATIONS > DSC OUTPUT > SELECT VESSELS. You can also select
ALL VESSELS to send data when you receive a call from any MMSI number, or select
NO VESSELS to not send data for any MMSI number.
3. Select the vessel in your directory.
4. Select from the following options:
ON—the radio will send call-related data over your NMEA network when you receive
a distress call, an acknowledgement to a position request call or other position send
call from this vessel.
•
•
•