Garmin 3000 Marine GPS System User Manual


  Open as PDF
of 10
 
2 GPSMAP 3000 Series Installation Instructions
To install the bail-mount bracket ➊:
1. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 2 in. (5.1 cm) of clearance behind
the GPSMAP 3000 series chartplotter for the wiring.
Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a
GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference.
2. Using an appropriately sized drill bit, drill the pilot holes for your mounting hardware.
3. Secure the bail mount to the surface with your mounting hardware.
To install the GPSMAP 3000 series chartplotter on the bail-mount bracket ➋:
1. Loosely attach the mounting knobs to the GPSMAP 3000 series chartplotter.
2. Slide the chartplotter onto the bail mount, and tighten the mounting knobs.
➊
RANGE
PAGE
QUIT
FCTN
FIND
ENTER
MARK
DATA
CNFG
ADJ
MENU
NAV
MOB
ABC DEF
JKLGHI MNO
TUV
PQRS
WXYZ
1
2
3
4
5
6
7
8
9
0
-
+
Bail mount
Mounting knobs
➋
Flush Mounting the GPSMAP 3000 Series Chartplotter
Use the included ush-mount template and hardware to ush mount your GPSMAP 3000 series chartplotter.
Make sure the surface on which you mount the chartplotter has at least 2 in. (5.1 cm) of open space behind it to t the chartplotter and the
connected wires.
Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a
GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference.
Hardware (included):
• Flush-mount template
• Four threaded mounting studs
• Fouratwashers
• Eight hex nuts
Tools required (not included):
• Jigsaw
• Masking tape
• Scissors
• Drill
• Drill bits—
1
/
8
" (3 mm) and
3
/
8
" (6 mm)
•
1
/
16
in. (2 mm) Allen (Hex) wrench
• 4 mm socket or wrench
• Marker
• Center punch and hammer
To ush mount a GPSMAP 3000 series chartplotter:
1. Theush-mounttemplateisincludedintheproductbox.Trimthetemplateandensureitwilltinthelocationatwhichyouwanttoush
mount the chartplotter.
2. Trimtheush-mounttemplateandtapeittothelocationatwhichyouwanttomountthechartplotter.
3. Using a
3
/
8
in. (10 mm) drill bit, drill one or more of the four pilot holes inside the corner of the template to begin cutting the mounting surface.
 previous next